20
3 POSITIONING CONTROL STARTUP
3.1 Creating a New Project
3 POSITIONING CONTROL STARTUP
3.1 Creating a New Project
1. Installing engineering software
Install MELSOFT iQ Works or MELSOFT GX Works3, following the Installation Instruction provided with the software
package.
2. Creating a new project
Start MELSOFT GX Works3, and create a new project.
[Project] [New]
Series : RCPU
Model : R04 (specify the CPU to be used)
Program language : Ladder
The window asking about module label addition appears. Click [Setting Change].
Product Model Description
MELSOFT iQ Works SW2DND-iQWK-E FA Engineering Software
• System Management Software [MELSOFT Navigator]
• Programmable Controller Engineering Software [MELSOFT GX Works3]
• Motion Controller Engineering Software [MELSOFT MT Works2]
• Screen Design Software [MELSOFT GT Works3]
• Robot Total Engineering Support Software [MELSOFT RT ToolBox2 mini]
• Inverter Setup Software [MELSOFT FR Configurator2]
MELSOFT GX Works3 SW1DND-GXW3-E Simple Motion module parameter settings, sequence program creation
Note) The screen windows in this document may differ from the ones you use.
(The system uses “MELSOFT GX Works3 Version 1.007H”)
View video:
To Next Page
Loading...
