2 - 32
2. DETAILS OF MIGRATION FROM Q17nCPUN(-T) TO RnMTCPU
2) Select the project to be diverted on the “Open GX Works2 Format Project” screen, and click
“OK”.
3) Check the following precaution at project diversion, and click “OK”.
[Precaution]
When MELSOFT GX Works2 projects are read by MELSOFT GX Works3, the
MELSEC-Q series PLC CPUs are automatically changed to R120CPU.
4) After MELSOFT GX Works2 project is read, click “OK”.
(Make sure to check the model change result in the output window.)
When the PLC CPU is replaced with other than R120CPU, execute the following 5) to 7).
5) Select “Change Module Type/Operation Mode…” in “Project” menu to open “Change
Module Type/Operation Mode” screen.
To Next Page
Loading...
