2 - 33
2. DETAILS OF MIGRATION FROM Q17nCPUN(-T) TO RnMTCPU
6) Select RCPU for “Series” and the replaced PLC CPU model for “Type” (the setting example
below: R08CPU). Click “OK”.
7) Click “OK” after confirming the precautions at model change.
The model change result is indicated in the “output window” of MELSOFT GX Works3.
The Motion CPU set for the multiple CPU system is also automatically converted to
R120CPU.
The procedure for changing R120CPU to RnMTCPU is described in the following 8) and later.
8) Double-click “System Parameter” in the navigation tree to open “System Parameter”
screen.
To Next Page
Loading...
