Mitsubishi Electric NZ2GN2B1-32D User Manual

256
APPX
Appendix 6 Added and Changed Functions
Appendix 6 Added and Changed Functions
The functions added to or changed in the I/O module are shown.
Added functions
The following table shows the functions that were added to the I/O module and the versions supporting these functions.
*1 The function can be used regardless of the version.
Function changes
The following table shows the functions that were changed in the I/O module and the versions supporting these functions.
Details of addition Firmware version Profile version Reference
Communication speed setting function "02" or later "01" or later Page 175 Communication Speed Setting Function
CC-Link IE TSN Network synchronous
communication function
• Synchronous X/Y control mode
"03" or later "02" or later Page 157 CC-Link IE TSN Network Synchronous
Communication Function
Ring topology "03" or later 
*1
Page 152 Network topology setting
"Station Information List" window display "03" or later 
*1
Page 193 Checking station information
CC-Link IE TSN Network synchronous
communication function
• Synchronization cycle timing control mode
• Set time synchronization control mode
"05" or later "03" or later Page 157 CC-Link IE TSN Network Synchronous
Communication Function
Details of change Firmware version Reference
Setting values of the communication cycle
interval setting
"02" or later Page 151 Communication cycle interval setting
Setting values of the communication cycle
interval setting
"03" or later Page 151 Communication cycle interval setting
Operation in multicast mode "03" or later Page 152 Communication mode

Mitsubishi Electric NZ2GN2B1-32D Specifications

General

Category	Controller
Model	NZ2GN2B1-32D
Number of Inputs	32
Input Voltage	24 VDC
Mounting	DIN rail
Weight	0.2 kg
Isolation	Photocoupler
Connection Type	Terminal block