Mitsubishi Electric Q06HCPU - Page 574

572
(14)Predefined protocol function
Number Name Meaning Explanation
Set by
(When
Set)
Corresponding
ACPU
D9
Corresponding
CPU
SD1337
Predefined
protocol setting
data error
information (for
built-in/adapter
serial
communications)
Stores
information for
identifying the
error location
of predefined
protocol
setting data.
The protocol number where an error has been detected
is stored.
• 0: No error
• 1 to 128: Protocol number
• 65535: Unidentifiable
If the value 65535 is stored, the following reasons are
considered.
• The setting that the current version of LCPU does not
support is written.
• The protocol setting data is collapsed.
S (Error) New
LCPU
*1
SD1338
The setting type of the protocol setting data where an
error has been detected is stored. (The value will be
stored only when the written protocol number is within
the range of 1 to 128.)
• 0: Packet setting or component setting
• 1: Protocol detailed setting
• 65535: Unidentifiable
If the value 65535 is stored, the following reasons are
considered.
• The setting that the current version of LCPU does not
support is written.
• The protocol setting data is collapsed.
SD1339
The packet number where an error has been detected is
stored. (The value is stored only when the setting type is
0 (packet setting or component setting).)
• 0: Transmitted packet
• 1 to 16: Received packet number
• 65535: Unidentifiable
If the value 65535 is stored, the following reasons are
considered.
• The setting that the current version of LCPU does not
support is written.
• The protocol setting data is collapsed.
SD1340
The component number where an error has been
detected is stored. (The value is stored only when the
setting type is 0 (packet setting or component setting).)
• 1 to 32: Component number
• 65535: Unidentifiable
If the value 65535 is stored, the following reasons are
considered.
• The setting that the current version of LCPU does not
support is written.
• The protocol setting data is collapsed.
SD1341
Number of
protocols
registered (for
built-in/adapter
serial
communications)
Stores the
number of
protocols in
the protocol
setting data.
This register stores the number of protocols in the
protocol setting data registered through the predefined
protocol support function
0: No registration
1 to 128: Number of protocols
S (Status
change)
New
LCPU
*1