8 - 21 8 - 21
MELSEC-Q
8 PROGRAMMING
(b)
Set only when the linear
counter is used.
Sets Coincidence signal No.1
reset command (Y1020)
Sets Coincidence output enable
command (Y1022)
Resets Y1020 after the counter
value coincidence signal is output
Resets Coincidence output
enable command (Y1022)
Turns on Coincidence confirmation LED
signal (Y30) in counter value coincidence
Resets Counter value
coincidence (Point No.1) (X1022)
Informs the reset completion of Counter
value coincidence (Point No.1) (X1022)
Executes Preset command (Y1021)
Resets Preset command (Y1021)
when the preset is completed.
To Next Page
Loading...
