α
2 Simple Application Controllers
AL2-GSM-CAB 8
ENG-38
8.2 Installation
When installing AL2-GSM-CAB refer to Figure 8.4.
Caution
• Persons trained in the local and national electrical standards must install or remove the
AL2-GSM-CAB.
• Turn off the power supply when installing or removing the AL2-GSM-CAB.
• Put the cover back on after either installing or removing the AL2-GSM-CAB.
• Under no circumstances will Mitsubishi Electric be liable or responsible for any
consequential damage that may arise as a result of the installation or use of this
equipment.
• Do not pull on the cord, otherwise the cable may be damaged.
• When communicating to
α2 series via GSM modem, the power supply for both units
must be turned ON at the same time. If they are not started up at same time, the
α2
series will not communicate via GSM modem.
• Disconnect all terminals from the power supply before removing the cover.
To Next Page
Loading...
