Automatic mode (Automatic air
conditioning)
E00764801113
In normal conditions, use the system in the
AUTO mode and follow these procedures:
1. Set the blower speed selection dial to the
“AUTO” position.
2. Set the temperature control dial to the
desired temperature.
3. Set the mode selection dial to the “AU-
TO” position.
The outlet position recirculation/outside air
select and blower speed, and ON/OFF of the
air conditioning will be controlled automati-
cally.
To stop the system, turn the blower speed se-
lection dial to the “OFF” position.
CAUTION
l
When using the air conditioning, the idling
speed may slightly increase as the air condi-
tioning compressor is switched on/off auto-
matically. While the vehicle with an A/T or
CVT is stationary, fully depress the brake
pedal to prevent the vehicle from creeping.
NOTE
l
While the engine coolant temperature is low,
the temperature of the air from the heater
will be cool/cold until the engine warms up,
even if you have selected warm air with the
dial. To prevent the windscreen and win-
dows from fogging up, the ventilator mode
will be changed to “ ” and the blower
speed will be reduced.
l
If the blower speed selection dial, air condi-
tioning switch, mode selection dial, or air se-
lection switch is operated while the system
is operating in the AUTO mode, the activa-
ted function overrides the corresponding
function of automatic control. All other
functions remain under automatic control.
Manual mode (Automatic air
conditioning)
E00764900032
Blower speed and ventilator mode may be
controlled manually by setting the blower
speed selection dial and the mode selection
dial to the desired positions. To return to au-
tomatic operation, set the dials to the “AU-
TO” position.
Demisting of the windscreen
and door windows
E00702100768
CAUTION
l
For safety, make sure you have a clear view
through all the windows.
Use the mode selection dial (“ ” or “ ”)
to remove frost or mist from the windscreen
or door windows.
Heater/Air conditioning
7-09
OGAE15E5
For pleasant driving
7