Changing the language cooper-
ative control
E00523301768
The language used in MITSUBISHI Multi-
Communication System (MMCS) (if so
equipped), the Bluetooth
®
2.0 interface (if so
equipped) or Multi Around Monitor (if so
equipped) can be changed automatically to
the same language as that shown in the multi-
information display.
1. Switch to the function setting screen.
Refer to “Changing the function set-
tings” on page 5-13.
2. Press the
switch or switch several
times to switch to the “LANGUAGE
SYNC” screen. Then, press the switch
to switch to the setting selection screen.
3. Press the switch or switch to select
the setting, and then press the switch
to confirm the setting.
The setting is changed to the selected
condition.
NOTE
l
The language display modified with the lan-
guage setting can be switched in the follow-
ing manner.
•
When “ON” (language cooperation ena-
bled) has been selected with the language
cooperative control, the language for
MITSUBISHI Multi-Communication Sys-
tem (MMCS) (if so equipped), the Blue-
tooth
®
2.0 interface (if so equipped) or
Multi Around Monitor (if so equipped) is
automatically changed to the language se-
lected for the multi-information display.
However, this changing function may not
work depending on the language selected
for the multi-information display.
•
When “OFF” (language cooperation disa-
bled) has been selected with the language
cooperative control, the language for
MITSUBISHI Multi-Communication Sys-
tem (MMCS) (if so equipped), the Blue-
tooth
®
2.0 interface (if so equipped) or
Multi Around Monitor (if so equipped) is
not automatically changed to the language
selected for the multi-information display.
NOTE
l
The language on the display of the audio
system (if so equipped) is not automatically
changed even if you select “ON” (language
cooperation enabled) of the language coop-
eration control.
Operation sound setting
E00523401815
You can change the operation sounds of the
multi-information display switches and rheo-
stat illumination button.
1. Switch to the function setting screen.
Refer to “Changing the function set-
tings” on page 5-13.
2. Press the
switch or switch several
times to switch to the “OPERATION
SOUND” screen. Then, press the
switch to switch to the setting selection
screen.
Multi-information display
5-18
OGKE18E1
Instruments and controls
5
To Next Page
Loading...
Need help?
General
