1
1
PRODUCT CHECKING AND PARTS IDENTIFICATION
1 PRODUCT CHECKING AND PARTS IDENTIFICATION
Unpack the inverter and check the capacity plate on the front cover and the rating plate on the inverter side face to ensure that
the product agrees with your order and the inverter is intact.
zInverter model
• Accessory
· Fan cover fixing screws (M3
×
35mm)
These screws are necessary for compliance with the EU Directive.
(
Refer to page 133
)
Capacity Number
1.5K to 3.7K 1
5.5K to 15K 2
Harmonic suppression guideline (when inverters are used in Japan)
All models of general-purpose inverters used by specific consumers are covered by "Harmonic suppression guideline for consumers who
receive high voltage or special high voltage". (For further details, refer to Chapter 3 of the Instruction Manual (Applied).)
Capacity plate
Inverter model
Serial number
Rating plate
FR-D740-1.5K
Inverter model
Input rating
Output rating
Serial number
1.5K
FR
--
Symbol Voltage class
D740 1.5
Represents the
inverter capacity [kW]
K
D720
Three-phase 200V class
D740
Three-phase 400V class
D720S
Single-phase 200V class
D710W
Single-phase 100V class
Control circuit terminal
block
(Refer to page 15)
Control logic switchover
jumper connector
(Refer to page 17)
Combed shaped
wiring cover
(Refer to page 6)
Main circuit
terminal block
(Refer to page 10)
Front cover
(Refer to page 4)
PU connector
(Refer to page 16)
Voltage/current input switch
(Refer to page 15)
Operation panel
(Refer to page 32)
To Next Page
Loading...
