Mitsubishi FR-D720-5.5K

24
Wiring
2.4.8 Connection to the PU connector
Using the PU connector, you can perform communication operation from the parameter unit (FR-PA07), enclosure surface
operation panel (FR-PA07), or a personal computer, etc.
Parameter setting and monitoring can be performed by FR Configurator (FR-SW3-SETUP-W).
Remove the inverter front cover when connecting.
zWhen connecting the parameter unit or enclosure surface operation panel using a connection cable
Use the optional FR-CB2 or connector and cable available on the market.
Insert the cable plugs securely into the PU connector of the inverter and the connection connector of the FR-PU07, FR-PA07
along the guide until the tabs snap into place.
Install the inverter front cover after connecting.
NOTE
Do not connect the PU connector to the computer's LAN port, FAX modem socket or telephone connector. The inverter
and machine could be damaged due to differences in electrical specifications.
REMARKS
 When using a commercially available connector and cable as a parameter unit connection cable, refer to Chapter 4 of the
Instruction Manual (Applied).
Parameter unit connection cable
(FR-CB2)(option)
PU connector
STF FWD PU
FR-PU07FR-PA07