93
DRIVE THE MOTOR
3
Parameter list
Parameter List
Maintenance of parts
503
Maintenance timer
10
0(1 to 9998)
Displays the cumulative energization time
of the inverter in 100h increments.
(Reading only)
Writing the setting of "0" clears the
cumulative energization time.
×××
504
Maintenance timer
alarm output set
time
19999
0 to 9998
Time taken until when the maintenance
timer alarm output signal (Y95) is output.
×
9999 No function
——
549
Refer to Pr.117 to Pr.124.
551
Refer to Pr.338 and Pr.339.
Current average
value monitor signal
555
Current average
time
0.1s 1s 0.1 to 1.0s
Time taken to average the current during
start bit output (1s).
556
Data output mask
time
0.1s 0s
0.0 to
20.0s
Time for not obtaining (mask) transient
state data.
557
Current average
value monitor
signal output
reference current
0.01A
Rated
inverter
current
0 to 500A
Reference (100%) for outputting the signal
of the current average value.
——
561
Refer to Pr.9.
563, 564
Refer to Pr.52.
571
Refer to Pr.13.
575 to 577
Refer to Pr.127.
611
Refer to Pr.57.
Reduce mechanical
resonance
653
Speed smoothing
control
0.1% 0 0 to 200%
The torque fluctuation is reduced to reduce
vibration due to mechanical resonance.
——
665
Refer to Pr.882.
872
Refer to Pr.251.
Function
Parameter
Name
Incre-
ments
Initial
Value
Range Description
Parameter
Copy
Parameter
Clear
All Parameter
Clear
Related
Parameter
To Next Page
Loading...
