109
Check and clear of the faults history
4
TROUBLESHOOTING
(2) Clearing procedure
POINT
Set "1" in Er.CL Fault history clear to clear the faults history.
Operation Display
1.
Screen at powering ON
The monitor display appears.
2. Press to choose the parameter setting mode.
PRM indication is lit.
(The parameter number read previously
appears.)
3. Turn until (faults history clear)
appears.
4. Press to read the present set value. " " (initial
value) appears.
5. Turn to change it to the set value " ".
6. Press to set.
Flicker...Faults history clear complete!!
Turn to read another parameter.
Press to show the setting again.
Press twice to show the next parameter.
To Next Page
Loading...
