Mitsubishi FR-D720-5.5K - Page 29

20
Wiring
3) Insert the wire into a socket.
When using a single wire or a stranded wire without a blade terminal, push an open/close button all the way down
with a flathead screw driver, and insert the wire.
zWire removal
Pull the wire with pushing the open/close button all the way down firmly with a flathead screwdriver.
NOTE
 When using a stranded wire without a blade terminal, twist enough to avoid short circuit with a nearby terminals or
wires.
 Place the flathead screwdriver vertical to the open/close button. In case the blade tip slips, it may cause to damage of
inverter or injury.
NOTE
 Use a small flathead screwdriver (Tip thickness: 0.4mm/tip width: 2.5mm).
If a flathead screwdriver with a narrow tip is used, terminal block may be damaged.
Introduced products :(as of Oct. 2008)
 Place the flathead screwdriver vertical to the open/close button. In case the blade tip slips, it may cause to damage of
inverter or injury.
Open/close button
Flathead screwdrive
r
Open/close button
Flathead screwdrive
r
Product Type Maker
Flathead screwdriver SZF 0- 0,4 x 2,5 Phoenix Contact Co.,Ltd.