MULTI-SPEED SETTING
1 st speed (high speed)
. El
2 nd speed (middle speed) m
3 rd speed (low speed)
[61
4 th speed •I &I
5 th speed
q q
6 th speed @I 161
7 th speed •I
q
3 -speed
setting
( 1 st function)
Multi-speed setting
( 2 nd function)
Only by switching external contact
signals, desired speed range can
be selected (SD is connected
to RH, RM or RL) .
Each speed (frequency) can be set
within the range from OHz to
360Hz.
Notes: 1. When ” 9999 ” is set
Time
(initial setting) for 4 th,
5 th, 6th or 7th speed,
these speeds are not operational.
2. If two speeds are selected from
1 st, 2 nd and 3 rd speeds at the
same time, the lower speed (frequency) is selected. (By default)
Ex.: When ” 40Hz ” and ” 50Hz ” are selected for high speed (RH) and
low speed (RL) respectively and RH- SD and RL -SD are closed
at the same time, then the output frequency (speed) is 50Hz.
Multi-speed input correction @ [IO
When multi-speed operation is done as described above, ” speed correction signal ’
can be input fromexternal signal source to correct speed (frequency) .
-103-
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
