SETTING TABLE
Acceleration/
deceleration
time
Description
Refer to
When the inverter is shipped, acceleration/
P. 83
deceleration time is set to 5 sec. for models P. 99
smaller than
7.5K,
and to 15 sec. for models
larger than
11K.
The time setting can be changed on the
parameter unit.
Acceleration/deceleration time is the time in
which the inverter output frequency becomes
equal to the frequency at
5 V of frequency
reference signal voltage.
Maximam
.output
frequency
0
For operation with external signals
P. 83
P. 97
When the inverter is shipped, the maximum
inverter output frequency is set as follows:
0
Voltage signal
---
6OHz
at DC 5 V (or
lOV>
0
Current signal
--+-*-
60Hz
at
DC20mA
Maximam
output frequency setting can be
changed by changing “frequency at 5 V
frequency reference input signal (or at 20mA
frequency reference signal)
“.
0
For operation with parameter unit
The maximum output frequency can be
increased up to the maximum frequency
limit (set to
120Hz
when the inverter is
shipped) .
Electronic
Setting should be based on current ‘value (at
P. 83
thermal relay
50Hz)
indicated on the nameplate of the motor.
P. 97
0
0
0
-22-
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
