--..-.. ,.. .-. I. -.. . . . . . . . . - “._. I.. ., ,,
4
*“c -...... --- .-
Description Refer to
Frequency reference
When an analog signa from an external
input signal signal source is
used as a speed ‘reference
(for . operation signal, the signal voltage range can be
with analog signal)
specified (up to DC 5 V or DClOV) by changing
engagement of “input signal select” connector
(CON5 > on the P.C. board.
When a potentiometer is connected to terminals
10, 2 and 5 directly, however, engagement of
the connector is not required to be changed.
. 1”’ operation with
For operation with
SIgnal Of DC O
tO
S V
l
sipa] of DC0 b. 1OV
;/f (;:,;yf (
Note: The inverter cannot be operated if the
connector is not engaged.
0 Operation with current signal (DC4 - 20mA)
DC current (DC4
- 20mA) is applicable when
terminal AU is connected to terminal SD.
See page 12.
Frequency meter
calibration
The frequency meter can be calibrated from P. 83
the parameter unit (without use of potentiometer
for calibration) .
-23-
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
