I
8
I
Voltage class
200v
Model FR-Z220-
FR-Z220
-0.4K (-0.75KI -1.SK I-2.2K I-3.7K 1 -5.5K 1 -7.5K 1 -1lK 1 -15K 1 -22K 1 -3OK 1 -37K 1 -45K 1 -55K
3 Output halt signal Output halt input signal termial is available.
‘2 Operation status output
Sk
‘RUN”, “SU” (up-to-frequency) , “ON” (overload) , “IPF” (instantaneous power failure) and
9
signals “FU” (frequency detection) signals
3
Alarm output signal 1 C relay contact signal (AC 230V 0.3A, DC 30V 0.3A)
Protective, alarm and warnin Overcurrent shutoff (during acceleration, deceleration and normal operation) , regenerative
functions overvoltage shutoff, undervoltage protection, instantaneous power failure protection, overload
shutoff, (electronic terminal relay) , brake transistor fault detection
(‘5
> , ground overcurrent
‘.
protection, output short-circuit protection, heatsink overheat protection 0
6
> , brake regenerative
resistor overheat protection (+5 >’ ,
stall prevention and overload alarm
Ambient temperature -10°C to +5O“C (to be free from freezing)
%
Ambient humidity
2
9O%RH or less (to be free from condensation)
E
Storage temperature (’ 7 > 1 -20°C to +65”C
‘5’ .
Atmosphere
Indoor
To be free from corrosive gases and. dense dust
3
Altitude, vibration
Below 10OOm (3300ft)
4
0.6G or less (conforms to JIS 0911)
Built-in optional units Maximum 2 cards. can be used.
Protective structure
(JEM 1030)
Enclosed type (IP20)
Open type (wx>)
Weight (kg) kg (Lb)
Notes : l
1. If the line voltage decreases, output voltage over the line
v&age
cannot be guaranteed.
l
2. Power supply capacity indicates the inverter input kVA and may change depending on power supply
impedance (including input reactor) .
* 3. This value may’ depend on motor loss.
* 4. JOG ,operation can be controlled not’ only with signal on JOG mode select terminal, but also parameter
unit.
* 5. This function is not provided for models FR-Z2WllK to 55K, and FR-Z2QO-11K to 55K.
0
0
0
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
