f-
(-
(31 JOG operation
To jog the motor, perform’ the following operation:
PU
q
l
OP
[ml l
m (or Ill)
The motor starts and runs only while m] or i-1 key is held
down.
@When the motor is started by pressing START key ((FWDI or [ml > ,
MONITOR mode is selected automatically and output frequency is displayed
(Note 1 >
l
While inverter output is on (during rotation of the motor) , the mode
indicator lamp just above
cl
l$ fliekers (the same occurs during DC
dynamic brake operation) .
(Note 2 .>
Notes: 1 . MONITOR mode is not selected automatically when a parameter unit
of previous specification (Spec. No. BKO-C2128) is used.
2. The lamp dose not flicker when a parameter unit of previous
specification (Spec. No. BKO-C2128) is used.
Examples of operation and indication
OExample where 60Hz is set for desired output frequency (from start to 60Hz)
Set to 60Hz
Start stop
P
x
g-Jm3
WEE
n n
REV
pw9 or -,
SS
OExample where speed is changed during operation (from 60Hz to 30Hz)
(Set to 60Hz)
Set to 30Hz
z
cl
E
W=E
E
.s
8
6
2
mj iQfjJ$fl: “A’
fV
Pressing
m clears alternating display and sets to selected frequency.
-79-
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
