FX1S Series Programmable Controllers Installation Notes 3
3-5
3.4 PLC Mounting Arrangements
To prevent a rise in temperature, mount the units to walls. Never mount them to the floor or
ceiling of an enclosure.
Caution
• Units should not be installed in areas subject to the following conditions: excessive or
conductive dust, corrosive or flammable gas, moisture or rain, excessive heat, regular
impact shocks or excessive vibration.
• Take special care not to allow debris to fall inside the unit during installation e.g. cut
wires, shavings etc. Once installation is complete remove the protective paper band to
prevent overheating.
Figure 3.3: PLC Mounting Diagram
FX
1S
CPU
A
A
AA
> 50mm(1.97 inches)
A
To Next Page
Loading...
Need help?
General
