6.
HQW
TO
USE EACH FUNCTION
uma
[Explanation]
(1)
When
"WRlTE
DISABLED" is selected
If
writing is,,executed when the CPU
is
in
the RUN state, the "PLC RUN"
message
is
displayed on the fourth line
of
the screen.
(2)
When "WRITE ENABLED: CONFIRM YES" is selected
If
writing is executed when the CPU
is
in the RUN state, the "PLC RUN,
PRESS
GO
KEY TO EXECUTE." message is displayed on the fourth line
of
the screen.
(3)
When "WRITE ENABLED: CONFIRM NO" is selected
Writing when the CPU is in the RUN state can be executed without
displaying the message when the CPU is in the RUN state.
(4) When "MONITOR
&
TEST" is selected
Only the following operations are possible with the monitoring and test
function:
.
MONITOR mode
................................................
Section 6.6
*TEST mode
.......................................................
Section 6.7
*OTHERS mode The T/C set value change
.....
Section 6.9.1
.....................
€
......
Error step read Section 6.9.2
Monitoring and switching
Sections 6.9.4,
of the PC system
6.9.5, 6.9.6,
PU setting
............................
Sections 6.9.1 4,
6.9.10, and 6.9.1
1
6.9.15, and 6.9.16
6 -92
1
I
f
f
Y
i
I
1
f
To Next Page
Loading...
