Mitsubishi MELSEC-A series

6. ,HOW .. TO USE EACH FUNCTION
MELSEGA
[Explanatlon]
(1) When executing NO? batch writing by "I: RANGE SET", designate the
start step and end step
in the range to be written.
NOP is written to the range from.the designated Start step to the end step.
(2) When executing NOP batch writing by "2: ALL", designate the start step
in the range
to be written.
NOP is written to the range from the designated start step to the end step
of the program.
(3) The start step and end step can be designated by using the [TI and [J]
keys to move the cursor to the step to be designated and press [GO] or
inputting the numbers.
6-3