To Next PageTo Next Page
Need help?Do you have a question about the Mitsubishi PLH-4AAK and is the answer not in the manual?
General| Phase | 1 |
|---|---|
| Energy Efficiency Ratio (EER) | 11.5 |
| Refrigerant | R410A |
| SEER | 16 |
| HSPF | 9.0 |
Identifies and describes key parts of the indoor unit, including air intake, outlet, filters, and vanes.
Provides detailed technical specifications for indoor units, including capacity, input, dimensions, noise, and weight.
Lists technical data for outdoor units, covering power supply, compressor, heat exchanger, and refrigerant details.
Presents cooling capacity data for various indoor and outdoor conditions, including capacity, heat capacity, and power consumption.
Provides heating capacity data for various indoor and outdoor conditions, including capacity, heat capacity, and power consumption.
Illustrates wiring diagrams, component legends, and connection points for indoor and outdoor units.
Details self-diagnosis error codes, symptoms, and procedures for emergency operation in case of controller failure.
Shows refrigerant flow diagrams for different model series, illustrating the path of refrigerant through key components.
Summarizes troubleshooting steps based on error code display and phenomenon recurrence, guiding service actions.
Explains how to use remote controllers for malfunction diagnosis, including button sequences and interpreting error codes.
Details error codes, causes, and countermeasures for specific issues like thermistor abnormalities and drain system faults.
Addresses issues related to controller board status (LEDs) and wiring faults, providing troubleshooting steps for each.
Provides a step-by-step guide for disassembling the indoor unit, including removing the intake grille, thermistors, and electrical box.
Lists and illustrates panel parts for the indoor unit, including quantities and part numbers for replacement.
