4 - 10
4.2 Wiring
4
PROCEDURE FOR STARTING UP A REDUNDANT
SYSTEM
(3) Connecting a Tracking Cable
Connect a tracking cable to CPU module tracking connectors according to the
following procedure.
(a) Confirming System A/System B Connectors
Confirm each connector of system A/system B.
(b) Connecting a Tracking Cable Connector
Align the tracking cable connector with the CPU module TRACKING connector,
and then connect them.
Make sure to tighten the tracking cable connector fixing screws after connecting
the tracking cable. (Tightening torque: 29.4 N•cm)
Diagram 4.6 Connecting a Tracking Cable Connector
Diagram 4.7 Fixing a Tracking Cable Connector
Redundant CPU
Connector
Tracking cable
Connector Screws
Flathead screwdriver
Tracking cable
To Next Page
Loading...
