26
Remote Control Functions: Channel Selection, Sleep Timer
Channel Selection
Enter three numbers ( ex. for channel 2, press 002).
or
Press the channel number and ENT (ex. for
channel 2, press 2, then ENT).
or
Enter the channel number and wait four seconds
(without pressing ENT). The TV will change
automatically.
Sleep Timer
(Figure 3 & 4)
Setting the Sleep Timer:
Press SLEEP on the remote control.
A message indicating the length of time the sleep
timer is to be set appears on the TV screen.
Each press of SLEEP will increase the time
displayed by 30 minutes, until the maximum value
of 120 minutes is reached.
After 5 seconds of inactivity, the message will
disappear.
Press SLEEP to view the remaining time before the
timer turns the TV off.
Canceling the Sleep Timer:
Press the SLEEP button to display the on-screen
message.
Press SLEEP repeatedly until OFF is displayed.
After 5 seconds of inactivity, the message will
disappear.
Sleep: min.
Figure 4. On-screen display for sleep timer
Note: Use the CANCEL button for digital subchannel (-)
selection in the CABLE/DBS/DTV layer.
Figure 3. Sleep button on remote control
TV
AUDIO
CABLE/DBS/DTV
DVD
VCR
To Next Page
Loading...
Need help?
General
