Mitutoyo EH Series - How to Read This Document; To Measure; Operation Key Names; Terms and Definitions

ix
No. 99MBC109B

How to read this document
z
When you do not know the appropriate operation while using this product
Look for the page with the desired operation in the table of contents.
z
To measure
The setup of this product and the settings of parameters are required in advance.
See the following pages for basic measurements, such as height measurement.
"1 Overview" (page 1) to "3.2 Basic Parameters" (page 12)
In addition to the pages above, see the following pages for applied measurements, such as
thickness measurement using 2-axis models.
"3.3 Advanced Parameters" (page 14) to "3.5 CEL-Specic Parameters" (page 21)
z
Operation key names
Operation key names are written side-by-side in the following way when an operation key
name differs between 1-axis models and 2-axis models: [Key name for 2-axis models]/[Key
name for 1-axis models].
z
Terms and denitions
y
INPUT A/INPUT B: Linear Gages connected to the Linear Gage input connectors A/B
y
Internal counter (CEL): The 4 internal counters that 2-axis models have (CEL1 to CEL4)
y
BANK: On 2-axis models, a display capable of being switched between 2 types (BANK1
and BANK2). BANK1 displays CEL1 and CEL2, BANK2 displays CEL3 and CEL4.
y
UNIT: The 6 counting methods that can be displayed on each CEL
Tips
For details about BANK, CEL, and UNIT, see "3.4.1 Internal Structure of the Counter" (page 17).