4 Basic Operations
26
No. 99MBC109B
» The displayed BANK will be switched.
Display A: CEL1
Display A: CEL3
Display B: CEL4
Display B: CEL2
Tips
The displayed BANK can also be switched by an external signal.
4.3
Zero Setting
The current value of the Counter can be set to 0 at any point within the Linear
Gage measuring range. Zero setting can be performed separately for each CEL.
This section explains how to perform Zero setting.
1
If Peak mode measurement has been set, switch to normal measurement.
» The counter value will be displayed.
(The gure on the right shows a
counter value of 1.000.)
Tips
For details about switching between Peak mode measurement and normal
measurement, see
"4.5 Peak Mode Setting" (page 28).
2
Select the BANK for which you want to perform Zero setting.
Tips
For details, see "4.2 Switching the Displayed BANK (2-Axis Models Only)" (page 25).
3
Press [A_ZERO]/[ZERO] or [B_ZERO].
» The counter value will change to 0.
» The maximum and minimum values that
were set in Peak mode will be cleared
(MAX = MIN = current value, TIR = 0).
To Next Page
Loading...