1 Overview
5
No. 99MBC109B
1.4
Operation Flow
The basic operation ow is explained below.
Do not omit the operations enclosed with a solid line. Perform the operations
enclosed with a dashed line as necessary.
Prep
Setup
"2 Setup" (page 7)
Set basic parameters
"3.2 Basic Parameters" (page 12)
Set advanced parameters
"3.3 Advanced Parameters" (page 14)
Measure
Prepare the workpiece
(Prepare the master workpiece as necessary)
Set the tolerance
"4.6 Tolerance Value Setting" (page 29)
Set the optional constant
"4.7 Optional Constant Value Setting"
(page 32)
Zero setting/Preset
"4.3 Zero Setting" (page 26)
"4.4 Preset" (page 27)
Normal measurement/Peak mode measurement
"4.5 Peak Mode Setting" (page 28)
Output
Result output
"5 External Input/Output Function"
(page 35)
To Next Page
Loading...