Mitutoyo EH Series - Page 37

3 Setting Parameters
23
No. 99MBC109B
No
No
No
Yes
EH-101P?
Yes
Yes
Continued from the previous page
[01] Parameter initialization
[02] Key protect
[06] Display mode selection
[07] Display at startup
[13] µ decimal point display
[14] Sum/Difference calculation
[15] Smoothing
[16] Peak value Preset
[18] Speed sampling cycle
[19] Digimatic input WAIT
[31] Origin detection direction
[32] Origin re-detection
[33] Origin initialization
[40] Individual CEL display
[41] Calculation with a constant
[42] Hide the lowest-order digit
[20] Tolerance/BCD
output switchover
[21] BCD output logic
[24] RS-232C/USB/Digimatic
output switchover
[25] Data transfer speed
[26] Parity check
[27] Data bit
[28] Output trigger
[30] Analog output range
[01] Parameter initialization
[02] Key protect
[07] Display at startup
[15] Smoothing
[16] Peak value Preset
[41] Calculation with a
constant
[42] Hide the lowest-order
digit
Set the display/
function?
Set external
Input/Output?
Setting complete
Advanced/
CEL-specic
parameters
For details about advanced parameters, see "3.3 Advanced Parameters"
(page 14).
For details about CEL-specic parameters, see
"3.5 CEL-Specic
Parameters" (page 21).