Mitutoyo EH Series - Page 47

4 Basic Operations
33
No. 99MBC109B
4.7.2 Procedure for Setting the Desired Multiplication Factor
This section explains how to set the desired multiplication factor for the selected
internal counter.
1
Press and hold [P.SET], and then press [A_ZERO]/[ZERO].
»
The Counter enters Parameter mode.
2
Press [A_ZERO] / [ZERO] 2 times to set the parameter number 00 to 2.
» The display appears as to the right.
3
Press [P.SET].
» The previous set value will be
displayed in Display A, and the CEL
number will be displayed in Display
B. (The set value of CEL1 will be
displayed as to the right.)
Display A
Display B
4
Press [MODE].
»
The input digit will shift to the right.
5
Press [A_ZERO]/[ZERO] or [B_ZERO].
» The multiplication factor will be
modied.
6
Repeat steps
4
and
5
until you have set the desired multiplication factor.
Tips
The setting range is ±9.99999.
7
Press [P.SET].
»
The multiplication factor for CEL1 is applied.
»
The set value of the next CEL will be displayed.
8
Set the desired multiplication factor in order for CEL2, CEL3, and CEL4 in as
explained in
4
to
7
.
»
The multiplication factors for CEL2, CEL3, CEL4 will be applied, and the Counter
will return to the Counter display.