Mitutoyo ID-C0550NXB - Auto off Setting

71
No. 99MAH057A
5 Setting Parameters
(Short press) / (Long press)
5.11.4 Auto OFF setting
The auto OFF function ON/OFF can be set. When set to ON, if there are no
changes in measured values, key operation, or output requests over 20 minutes,
the power will go OFF automatically.
2
31
F2
F1/F3
F2
Go to the
next item
1 Pressthe[F2]key.
» Auto OFF setting is enabled.
2 Pressthe[F1]keyor[F3]key.
» Each time the key is pressed, the auto OFF switches between ON and OFF.
3 Pressthe[F2]key.
» Settingsareconrmed;shiftstothenextparameteritem.
(Go to "5.11.5 All Reset" on page 72.)
Tips
• Auto OFF is enabled when exiting parameter setting mode and returning to
measurement mode.
• To turn the power ON after auto OFF, press the [F2] key.
• The auto OFF function is disabled in parameter setting mode.