MK Welding Multi-GMAW 200 DP PFC - English

EN
CONTENT
§1 SAFETY 1
§1.1 SYMBOLS EXPLANATION 1
§1.2 MACHINE OPERATING WARNINGS! 1
§1.3 EMC DEVICE CLASSIFICATION 8
§1.4 EMC MEASURE 9
§1.5 WARNING LABEL 10
§2 OVERVIEW 11
§2.1 FEATURES 11
§2.2 TECHNICAL DATA 12
§2.3 BRIEF INTRODUCTION 13
§2.4 DUTY CYCLE AND OVER-HEAT 14
§2.5 WORKING PRINCIPLE 14
§2.6 VOLT-AMPERE CHARACTERISTIC 15
§3 PANEL FUNCTIONS & DESCRIPTIONS 16
§3.1 MACHINE LAYOUT DESCRIPTION 16
§3.2 CONTROL PANEL OF WELDING MACHINE 17
§4 INSTALLATION & OPERATION 26
§4.1 INSTALLATION & OPERATION FOR MMA WELDING 26
§4.1.1 SET UP INSTALLATION FOR MMA WELDING ..................................................... 26
§4.1.2 MMA WELDING ......................................................................................... 26
§4.1.3 MMA WELDING FUNDAMENTALS .................................................................. 28
§4.2 INSTALLATION & OPERATION FOR TIG WELDING 30
§4.2.1 SET UP INSTALLATION FOR TIG WELDING ......................................................... 30
§4.2.2 DC TIG WELDING ........................................................................................ 34
§4.2.3 TIG WELDING FUSION TECHNIQUE ................................................................. 36
§4.2.4 TUNGSTEN ELECTRODES ................................................................................ 37
§4.2.5 TUNGSTEN PREPARATION .............................................................................. 40
§4.2.6 GUN SWITCH CONTROL CURRENT .................................................................... 42
§4.3 INSTALLATION & OPERATION FOR MIG WELDING 43
§4.3.1 SET UP INSTALLATION FOR MIG WELDING- GAS SHIELDED WIRE .......................... 43
§4.3.2 WIRE FEED ROLLER SELECTION ....................................................................... 47
§4.3.3 WIRE INSTALLATION AND SET UP GUIDE .......................................................... 48
§4.3.4 SET UP INSTALLATION FOR MIG WELDING- GASLESS WIRE ................................. 50
§4.3.5 MIG TORCH LINER INSTALLATION ................................................................... 54
§4.3.6 MIG TORCH LINER TYPES AND INFORMATION .................................................. 56
§4.3.7 TORCH & WIRE FEED SET UP FOR ALUMINIUM WIRE ........................................ 57
§4.3.8 SET UP INSTALLATION FOR SPOOL GUN ............................................................ 60
§4.3.9 MIG WELDING ............................................................................................ 62
§4.3.10 MIG TORCH /SPOOL GUN CONTROL ............................................................. 70