To Next Page
M
Mark WalshNov 4, 2025
Why is there excessive spatter when using my MK Welding System?
- CCaleb OlsonNov 5, 2025
Excessive spatter in your MK Welding System can be caused by several factors. Here's what to check: * **Wire feed speed:** Reduce the wire feed speed. * **Voltage:** Lower the voltage setting. * **Polarity:** Ensure you've selected the correct polarity for the wire you're using. Consult the machine setup guide for details. * **Stick out:** Bring the torch closer to the workpiece. * **Base metal contamination:** Clean the base metal to remove paint, grease, oil, dirt, and mill scale. * **MIG wire contamination:** Use clean, dry, rust-free wire, and avoid lubricating it with oil or grease. * **Gas flow:** Verify the gas is connected, and the hoses, gas valve, and torch are not restricted. Set the gas flow between 6-12 l/min. Inspect hoses and fittings for leaks, and protect th...
General