Cleaning and caring for the unit
56 Operating instructions
ATTENTION
Risk of physical damage from deposits
• Check the steam outlet and connected piping for deposits.
Use a liquid cleaner containing at most 20% sodium or
potassium hydroxide.
Flushing with water is not necessary.
1. Examine the steam outlet and connected piping for deposits.
2. Spray liquid cleaner into the steam outlet.
6.9 Removing calcium deposits from the unit
To remove calcium deposits manually, fill a manual spray gun
with a special decalcifier.
Prerequisite
Cooking zone temperature less than 40 °C
Cooking zone cleaned
1. Dilute special decalcifier with water in a ratio of 1:2.
2. Spray the diluted special decalcifier into the cooking zone.
3. Allow to act for 30 minutes.
4. Rinse the cooking zone thoroughly.
5. Examine the cooking zone for any remaining calcium deposits.
6. If necessary, repeat the decalcification.
7. Open the cooking zone door and leave it ajar until the unit is used
again.
This extends the service life of the door seal.
No moisture builds up in the cooking zone.
10015160-0ABBE--
To Next Page
Loading...
