IG7600 Administration Manual
Copyright 2013 Tecom, Co. LTD. All rights reserved Page 95 of 95
The configurable items for each part would be described in the following.
6.6.4.1 General
This page allows you to configure the general settings of the auto attendant and voice
mail.
Auto Attendant: (Figure 6-72)
Admin Password: The password of administrator.
AA No Answer Time: When a call is being transferred by AA, this timer will do a
count down. When time is up, the callee is considered to be unavailable. AA will play
10206.vox then, to guide the caller what to do next.
Note: The timer must be shorter than the Reroute Timer of UCD Group, because
only one of them can take effect.
Max Try Time: Maximum error times for extension’s key input.
Action When Max Error Reached: You can set the system “Forward to operator” or
“Disconnect” when reaching the “Max Try Time” errors for key input.
Prompt Language: Automated Attendant language type. It provides one or two
languages to be chosen.
VAA Codec: Choose the codec of auto attendant.
RTP Packet Size: Choose the RTP packet size of auto attendant.
DISA: Enable/Disable DISA. When enable DISA, Auto Attendant plays the Greeting
message and the Caller dials “#” key, caller can make an outside call. When disable
DISA, caller can’t make an outside call.
Dial by Name Code: This code is used as an entry code of Dial by name function in
AA process. It is a disabled function by default. You should activate it manually by
input a number here.
Single Digit Table: This entry is for users to configure a speed dial table for each AA
menu. (Figure 6-73)
Greeting Mode: This controller is for you to select greeting mode of AA
To Next Page
Loading...
