IG7600 Administration Manual
Copyright 2013 Tecom, Co. LTD. All rights reserved Page 19 of 19
Basically in one IGW Group we demand one of the IGs works under master mode, others
work under slave mode. The members in the group need to be found by each other on
the internet make sure about it before you use this function. When an IGW Group is build
up successfully we can choose IGW Group as a Call Routing way in Call Routing
configuration page.
When IGW Group Settings are OK and Call Routing table is set appropriately, Ext under
one IG can call another IG’s Ext or use its Trunk resource directly. IGW Group only
supports Exts from different IG having conference call only when the Initiator is a specific
IP Phone, M54(-i) is not supported.
1. We have a figure and a table to describe what IGW Group supports.
To Next Page
Loading...
