EasyManua.ls Logo

modway Regent EEI-3608 User Manual

modway Regent EEI-3608
3 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
EEI-3608&3609 OFFICE CHAIR
Customer Service 609-256-9000www.modway.com
Page 1 of 3
Thank you for purchasing the MODWAY OFFICE CHAIR!
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2. Owing to the size and weight of the office chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6. Please keep all pieces out of reach of children.
Hardware:
Components:
Bolt M6x45mm x4
1. Base x1 2. Cylinder Column x1 3. Castor x5
A.
Allen Wrench x1
4. Control Mechanism x1 5. Top x1
B.
Flat Washer x4
C.
Question and Answer IconNeed help?

Do you have a question about the modway Regent EEI-3608 and is the answer not in the manual?

modway Regent EEI-3608 Specifications

General IconGeneral
Brandmodway
ModelRegent EEI-3608
CategoryIndoor Furnishing
LanguageEnglish

Summary

STEP 1: Base and Cylinder Assembly

Base and Castor Assembly

Insert castors into the base, repeat for all five, and turn over the assembled base.

Cylinder Column Insertion

Insert the cylinder column into the assembled base.

STEP 2: Attaching Control Mechanism

Connect Mechanism to Seat Top

Attach control mechanism to the top using bolts and flat washers, tightening with Allen wrench.

STEP 3: Final Assembly

Connect Seat to Cylinder

Insert the control mechanism into the cylinder column.

Related product manuals