Moomba Mojo User Manual

27
© 2014 Skier’s Choice, Inc.
CenTeR DRaIn PlUg-DIReCT DRIVe MoDels
The bilge area drain plug is located at the front of the motor
well, in the center under the engine.
It is extremely important that the drain plug is always checked
before starting the engine. The drain plug should be secured
in place using a wrench.
DO NOT start engine until center drain plug is checked and
secured in place. DO NOT try to install center drain plug
while engine is running.
Some Moomba models DO NOT have mechanical devices to
hold the motor box cover in the open position. Please use
caution to prevent accidental closing.
ReaR DRaIn PlUg
The rear drain plug is located at the back of the boat, near
the bottom of the transom. It is extremely important that the
drain plug is always checked before starting the engine. The
drain plug should be secured in place using a wrench.
DO NOT start the engine until the drain plug is checked
and secured in place. DO NOT try to install the drain plug
while the engine is running!
CenTeR DRaIn PlUg -V-DRIVe MoDels
On V-drive models the center drain plug is accessed via the
access cover in the center oor panel.
It is extremely important that the drain plug is always checked
before starting the engine. The drain plug should be secured
in place using a wrench.
DO NOT start engine until center drain plug is checked and
secured in place.
CoVeR laTCH
DRaIn PlUg

Moomba Mojo Specifications

General

Beam	102 inches
Wakeboard Tower	Standard
Length	23 ft
Fuel Capacity	70 gallons
Engine	400 Indmar Raptor 6.2L
Ballast Capacity	4, 000 lbs
Engine Options	Indmar Raptor 6.2L 400