-73-
CAUTION
Do not attempt to repair or modify a damaged wheel. Even minor
modifications can cause a dangerous failure of the wheel and result
in personal injury or death.
Torque Requirements
In June of 2004, Dexter ceased production of trailer wheels. If your vehicle is
equipped with Dexter steel wheels manufactured before that date, the following
wheel torque information will be applicable.
If your trailer is equipped with wheels produced by other manufacturers, you
must consult with the vehicle manufacturer to determine the appropriate torque
level for your wheels. However, you must not exceed the limits of the wheel
mounting studs on the axles.
It is extremely important to apply and maintain proper wheel mounting torque
on your trailer axle. Torque is a measure of the amount of tightening applied to
a fastener (nut or bolt) and is expressed as length force. For example, a force of
90 pounds applied at the end of a wrench one foot long will yield 90 Ft. Lbs.
of torque. Torque wrenches are the best method to assure the proper amount of
torque is being applied to a fastener.
CAUTION
Wheel nuts or bolts must be tightened and maintained at the proper
torque levels to prevent loose wheels, broken studs, and possible
dangerous separation of wheels from your axle, which can lead to an
accident, personal injuries or death.
Be sure to use only the fasteners matched to the cone angle of your wheel
(usually 60° or 90°). The proper procedure for attaching your wheels is as
follows:
1. Start all bolts or nuts by hand to prevent cross threading.
2. Tighten bolts or nuts in the sequence shown for Wheel Torque
Requirements.
Wheels and Tires
To Next Page
Loading...