October 2020 LOR Digital Controller (LDC)
Cautions and Warnings
Warning: Before welding on the Machine, ensure that all connectors are disconnected from
the system. Failure to do so could result in damage to the system itself or its components.
Caution: Improper operation of these controls could cause damage to equipment. Do not
allow anyone to operate this equipment before completely reading this manual.
Caution: LOR Manufacturing Company, Inc. controls are intended as general purpose
switches. They are not safety devices. Malfunctions may occur. LOR Manufacturing Prod-
ucts are used to initiate an operation where false operation could be dangerous. Point-of-
Operation guarding devices must be installed and maintained to meet OSHA and ANSI Ma-
chine Safety Standards. LOR Manufacturing shall not accept responsibility for installation,
application, or safety of systems.
14 LOR Manufacturing Company, Inc.
To Next Page
Loading...