2-9
[6] ENGINE OIL PRESSURE LAMP
This warns the operator that the engine oil pressure has dropped.
It should be out during operations.
If it lights up during operations, the engine oil pressure has dropped.
Stop operations immediately and check for the cause.
Check the engine oil level. Check also for clogging of the engine oil filter.
If the inspection shows that there is no abnormality, please contact your
distributor.
[7] OVERRUN CARE LAMP
If this lamp lights up when traveling downhill, it means that the machine is in an extremely dangerous situation.
Carry out the following emergency operation to stop the machine immediately.
1. Return the travel lever to the N position and apply the brakes.
2. When the machine stops, move the dump control lever to the RAISE position to dump the load and reduce the
weight.
3. Return the throttle lever to the LOW SPEED position to reduce the engine speed.
4. Put the travel lever as close as possible t the N position, then start traveling downhill again.
The overrun care indicator may also light up when the engine is accelerated under no load, or when the machine
is traveling unloaded on flat ground, but this does not indicate any abnormality.
When the machine is traveling on a slope, this warns the operator that the
machine is in an extremely dangerous situation.
The monitor lights up if the engine and HST (main pump, travel motor) exceed
the normal maximum engine speed when traveling downhill.
[8] OVERRUN DANGER LAMP
• If this lamp lights up when traveling downhill, it means that the machine is in an extremely dangerous situation.
Carry out the following emergency operation to stop the machine immediately.
1. Return the travel lever to the N position and apply the brakes.
2. Return the throttle lever to the LOW SPEED position to reduce the engine speed.
3. If it is not possible to stop the machine completely, set the parking brake switch to the STOP position to apply
the parking brake.
• If the emergency brake has been used in such an emergency, always carry out inspection and repair of the
parking brake. If the machine is used without checking the parking brake, there is danger that the parking brake
may not work effectively.
When the machine is traveling on a slope, this warns the operator that the
machine is in an extremely dangerous situation.
The monitor lights up if the engine and HST (main pump, travel motor) exceed
the danger limit for the engine speed when traveling downhill.
To Next Page
Loading...