2-21
2.10 OPERATOR’S SEAT Applicable to Canopy Specifications
• Adjust the operator’s seat before operations. Always adjust the
operator’s seat after it has been used by another operator.
• Adjust the operator’s seat so that you can operate the travel lever
easily with your back against the seat backrest.
• Never adjust the seat when traveling.
• Always lower the armrest before starting operation. The armrest is
installed to prevent the danger of the operator falling from the
operator’s seat if the machine tips at an angle when traveling.
[1] ADJUSTMENT OF SEAT FRONT - REAR SLIDE
Sit in the seat, use front-rear slide lever (1) at the seat forward under right side
to adjust.
1. While pulling lever (1) to the right, move the seat forward or backward to set
it to a desired position.
2. Take your hand off lever (1), and press the seat slightly to lock the seat.
[2] ADJUSTMENT OF RECLINING ANGLE
Sit in the seat, use reclining adjustment lever (2) at the seat left back side to
adjust the reclining angle.
1. While pulling lever (2) up, sit up straight to move your back away from the
backrest. The backrest tilts forward.
2. While pulling lever (2) up, press your back against the backrest, and keep
pressing until the backrest reaches your desired position.
3. Take your hand off lever (2), and press the backrest slightly to lock the seat.
[3] ADJUSTMENT OF ARMREST
Armrest (3) moves up and down.
When getting in or out of the operator’s compartment, raise the armrest.
When sitting in the operator’s seat and carrying out operations, always lower
the armrest.
[4] ADJUSTMENT OF HEADREST
Headrest (4) can be adjusted up or down.
While pressing knob (5), move headrest (4) up or down.
To remove the headrest, move it up all the way.
To Next Page
Loading...