31
6. Operation
4 - Pull the start handle (4) until you feel resistance, then
pull vigorously in the arrow’s direction.
5 - Gently return the starter handle to its position, without
hitting the engine.
* Important
• When the engine starts, the machine immediately
reaches maximum speed for about 7 seconds, and
then automatically decreases to the lowest speed.
• During operation, the engine speed increases to a
maximum when power is drawn during welding or
auxiliary power supply of power tools.
4
D5261060
6.3.2 Stopping the engine
WARNING
• Before stopping the engine, disconnect or close any load connected to the system auxiliary
generation and stop the welding.
• In case of emergency, turn the engine switch (3) to the OFF position.
1 - Wait for the engine to decrease the rotations to the minimum speed (about 6-7 seconds after the loads
are disconnected), then wait a few minutes for it to cool down.
2 - Turn the emergency switch (3) to the OFF position.
O
I
3
D5261070
OFF
ON
3 - Turn the fuel valve (1) to the OFF position.
1
D5261080
OFF
To Next Page
Loading...
