dot) on the radio to the Bluetooth Pairing Location (a
blue dot) on the accessory.
If the pairing process is successful, you hear an
incremental-pitched tone. The radio begins to
connect to the device.
If the pairing process fails, you hear a short, low-
pitched tone. The display shows Bluetooth
pairing failed. Repeat this step.
The radio tries to establish connection with the device once
paired.
NOTE:
If the connection fails within 6 seconds, you hear a
decremental-pitched tone to indicate that the device
is unpaired. The display shows <Device Type>
unpaired. Repeat this step to re-initiate the pairing
process.
If the connection is successful, you hear an incremental-
pitched tone. The display shows <Device Type>
connected and the Bluetooth icon turns from to .
If the radio has the pairing record of the device and the
connection fails, you hear a short, low-pitched tone. The
display shows <Device Type> connect failed.
Radio Indications of Lost Bluetooth
Connection
The radio shows when the device has a Bluetooth
connection. Below are the radio indications when the
connection is interrupted.
The starts blinking for up to 10 seconds. You hear a
decremental-pitched tone. The display shows <Device
Type> alternating with disconnected.
If the Bluetooth device successfully re-connects before the
Bluetooth 10 second Re-Connection Timer expires, the
display shows momentary <Device Type> connected,
and stops blinking, or if the Bluetooth device fails to re-
connect within 10 seconds, the blinking is replaced by a
persistent .
English
164 Send Feedback
To Next Page
Loading...
