Standard Pairing Feature
NOTE:
Bluetooth tones, Bluetooth menu and
preprogrammed buttons must be preprogrammed
by a qualified radio technician. Check with your
dealer or system administrator for more information.
Once a COTS headset is paired to your radio, it is
always connected. Therefore the battery life of the
accessory is aligned with the Talk time power
consumption and not the Standby time
consumption.
The Bluetooth Standard Pairing feature enables your
Bluetooth enabled radio to search for other Bluetooth
enabled and discoverable devices. Once a device is
discovered, you can initiate your radio to send a pairing
request to pair with the device.
This feature also enables your Bluetooth enabled radio to
be visible to other Bluetooth enabled devices and receive
request to pair from other devices.
The Standard Pairing feature supports pairing
Authentication Personal Pairing Number or PIN which
ensure your radio recognizes the correct device to pair. The
PIN must be exchanged with the radio or the device before
the pairing completes. Your radio prompts for the
Authentication PIN when needed. Refer to your device’s
manual for details about the Bluetooth Authentication PIN
of your device if needed.
Searching and Pairing the Bluetooth
Device
Ensure the Bluetooth on your device is turned on and is set
to Discoverable in order to enable your radio to detect
your device in Bluetooth.
Bluetooth Search in Bluetooth Standard Pairing method is
used to scan for other Bluetooth devices nearby. It is set to
turn off by default.
1
Perform one of the following actions:
• Press the preprogrammed Bluetooth Search
button.
• or to BT. Press the Menu Select button
directly below BT to access the Bluetooth feature
screen. or to Search Devices and press
the Menu Select button directly below On.
If successful, the display shows Searching for BT
devices followed by the names of Bluetooth devices
found, if any. When the search timer expires,
English
Send Feedback 165
To Next Page
Loading...
