Classification of Regrouped Radios
The dispatcher can classify regrouped radios into either of
two categories:
Select Enabled
Select-enabled radios are free to change to any
available channel, including the dynamic-regrouping
channel, once the user has selected the dynamic-
regrouping position.
Select Disabled
Select-disabled radios cannot change channels while
dynamically regrouped. The dispatcher has forced the
radio to remain on the dynamic-regrouping channel.
The Scan or Private Call feature cannot be selected while
your radio is Select Disabled.
Zone to Zone Cloning
Zone to Zone Cloning clones conventional zones from one
radio to another. This feature allows you to select the clone
enabled zones from a source radio and clone them into a
target radio.
You can clone the zones by using a cable that connects the
source and target radios.
Connect two radios with a clone cable. The target radio
must be digital, band, and FCC mandate compatible with
the source radio.
1 On the source radio, press the Menu Select button
directly below Clon.
2
Press the Menu Select button directly below Sel to
select source zone.
3 When connecting to the target radio, one of the
following scenarios occurs:
• If the radio is compatible, the radio displays
Target radio connected. Proceed to step 4.
• If the radio is not compatible, the radio displays
Target radio incompatible. Press the Menu
Select button directly below Ok and the radio
returns to the previous screen.
Once connected, the zone clone status is displayed
on the right.
4
Press the Menu Select button directly below Next to
accept the source zones selection. One of the
following scenarios occurs:
English
55
To Next Page
Loading...
