Restoring a Nuisance Channel
To restore the deleted nuisance channel, perform
one of the following actions:
• Stop and restart a scan.
• Mode change to another channel and back to the
original channel.
• Turn off the radio and then turn it on again.
Nuisance mode delete can be disabled by the
system administrator.
Call Alert Paging
This feature allows your radio to work like a pager.
The radio which you missed its call can send a Call Alert
page to your radio. The sender also able to know that your
radio is active.
NOTICE:
This feature must be preprogrammed by a qualified
radio technician.
Receiving a Call Alert Page
When you receive a Call Alert page, you hear four
repeating alert tones and the LED blinks green. The call
received icons blinks and the display shows PAGE RCV.
Press any button to clear the Call Alert page.
Sending a Call Alert Page
Your radio must be preprogrammed for you to use this
feature.
• Press the preprogrammed Quick Access (One-
Touch) Call Alert Paging button to send a page to
the preprogrammed ID.
If the call alert page is sent successfully, a tone
sounds and the display shows the current zone and
channel name.
If the call alert page is not acknowledged, a tone
sounds and the display shows the current zone and
channel name.
English
59
To Next Page
Loading...
