Motorola APX 8000XE 1 - Receiving Pairing Request from Other Devices; Turning on Bluetooth Visibility; Turning on the Bluetooth Audio

Turning On Bluetooth Visibility
Turning Bluetooth visibility on enables other Bluetooth
devices to search for your radio. The visibility of the
Bluetooth is set to turn off by default.
• a. Press and hold the preprogrammed Bluetooth
Inquiry On/ Off button for three seconds to
enable the Bluetooth visibility feature.
One of the following scenarios occurs:
• Keep holding the button although you hear a
short, medium-pitched tone with the display
shows momentary VISIBLE. This indicates the
visibility is turned on successfully.
2
• If the visibility fails to turn on, the display
shows VISIBLTYFAILED.
• When the timer expires, the display shows
VISI OFF.
Receiving Pairing Request from other
Devices
Turn on your radio Bluetooth Visible mode.
Your radio automatically accept the request and pair
with any request received from other device.
Turning On the Bluetooth Audio
• Turning on the Bluetooth audio using the
preprogrammed button:
a. Press the preprogrammed Bluetooth Audio
Reroute button to route the audio from the radio
to the headset.
You hear a short, medium-pitched tone. The
display shows HDSET ON.
BT audio routing can be configured in CPS to route
the audio to RSM or radio's internal speaker. The
audio routes to the radio's speaker if RSM is not
connected. Check with your dealer or system
2
Releasing the preprogrammed button turns off the Visibility mode.
English
90