a. Long press the preprogrammed Bluetooth
On/Off button.
You hear a short, medium-pitched tone. The
display shows PLS WAIT to indicate clearing is in
progress.
If successful, the display shows ALL CLR.
If unsuccessful, the radio sounds a short, low-
pitched tone.The display shows CLR FAIL.
NOTICE:
If Re-Pair Timer is set to infinite and you clear keys
on the radio, you must clear keys on all previously
paired devices as well. (Please see your
accessories manual for further details.)
Holster Sensor
Holster sensor allows the radio to send notification over-
the-air (OTA) when a holster event or multiple holster
events occurs.
To enable the feature, ensure that the GPS, Enhanced
Data, and Bluetooth feature of your radio is on and the
radio supports Bluetooth Low Energy (BT-LE).
You can disable the sensor temporarily or permanently.
This feature allows you to suppress one or all holster
events from being reported OTA.
This feature is enabled through CPS configuration. Check
with your dealer or system administrator for more
information on the programming of this feature.
Disabling Holster Sensor Temporarily
1 Short-press the preprogrammed Sensor button to
disable OTA Sensor notification.
A tone sounds and the radio displays Sensor
Disable.
2 The radio remains in this state for a time specified in
radio's codeplug programming. If the timer expires
without an unholster event, a tone sounds, the radio
re- enables the sensor feature and clear sensor
status from the display.
3 When the gun is placed back in the holster, a tone
sounds, the radio enables the OTA sensor
notification and the radio displays Sensor On
temporarily.
English
92
To Next Page
Loading...
