NOTICE:
If the transmitting radio is stale at its location after a
period of time, the receiving radio display shows
ID:<PTT ID> LKL: <Coordinates> <distance>.
If the radio is not configured to show PTT ID, you
see LAST KNWN LOC: <Coordinates>
<distance>.
If the transmitting radio does not have GPS or the
receiving radio could not decode the GPS signal of
the received signal, the receiving radio display
shows ID:<PTT ID> UNK LOC. The PTT ID seen
here is optional to be shown on the display per
requirement of usage.
Trunking System Controls
This chapters explains the trunking system control features
in your radio.
Operating in Failsoft System
The failsoft system ensures continuous radio
communication during a trunked system failure. If a
trunking system fails completely, the radio goes into failsoft
operation and automatically switches to its failsoft channel.
During failsoft operation, your radio transmits and receives
in conventional operation on a predetermined frequency.
You hear a medium-pitched tone and the display shows
FAILSOFT.
When the trunking system returns to normal operation, your
radio automatically leaves failsoft operation and returns to
trunked operation.
To continue in Failsoft and to communicate with other
talkgroups, refer to the following procedure.
1 Rotate the Mode Knob to change to a different
repeater frequency.
2 Press the PTT button to talk, and release the button
to listen.
Out-of-Range Radio
When your radio goes out of the range of the system, it can
no longer lock onto a control channel.
You hear a low-pitched tone and/or the display shows the
currently selected zone/channel combination and OUT RNG.
Your radio remains in this out-of-range condition until it
locks onto a control channel, it locks onto a failsoft channel,
or it is turned off.
English
82
To Next Page
Loading...
